This is just responsible for a few cycles every frame (could be around 1
and 2% depending on the game usage) but makes emulation a bit more
accurate and potentially faster.
This fixes a race condition that happens whenever the ROM cache is flushed but
the RAM one is not, causing any SWI calls (implemented as direct branches) to
jump to random instructions.
The fix could be to flush both caches at the same time (~expensive on
low mem platforms), use indirect jumps (a bit expensive) or emit the SWI
handler below the watermark to ensure it is never flushed. This is cheap
and effective, requires minimal changes.
This uses BSON as savestate format, to allow external tools to parse it
(so that we can add proper test of the states). The BSON is not 100%
correct according to spec (no ordered keys) but can be parsed by most
libraries.
This fixes also a bug in the savestate palette color recalculation that
was wrongly overwritting the original palette (which could cause some
problems on some games).
Also fixes some potential issues by serializing some more stuff and
cleans up unused stuff.
Testing shows that states look good and there's only minor differences
in audio ticks, related to buffer sizes (since buffer flushes are
de-synced from video frames due to different frequency).
This is not needed at all, since the variables are not updated between
reload and end-of-frame (where we take our savestates). Added a reload
call during gba_load_state() to initialize it from the I/O regs.
This patch adds big-endian compatibility in gpsp (in general but only
for the interpreter). There's no performance hit for little-endian
platforms (should be a no-op) and only add a small overhead in memory
accesses for big-endian platforms.
Most memory accesses are wrapped with a byteswap instruction and I/O reg
accesses are also rewired for proper access (using macros). Video
rendering has been fixed to also do byteswaps but there's a couple of
games and rendering modes that still seem broken (but they amount to
less than 20 games in my tests with 1K ROMs).
This also adds build rules and CI for NGC/WII/WIIU (untested)
Added a more thorough cache cleanup for reset/mode-change too.
Fixed the mmap initialization that ends up leaking memory.
Minor x86 asm fixes for Android.
This is not really necessary since it can share area with ROM.
Performance impact should be very minimal (haven't noticed it myself)
and could be compensated (even by a positive offset) if we bump the ROM
cache area size.
Tested with several dynarecs.
This allows us to emit the handlers directly in a more efficient manner.
At the same time it allows for an easy fix to emit PIC code, which is
necessary for libretro. This also enables more platform specific
optimizations and variations, perhaps even run-time multiplatform
support.
This removes libco and all the usages of it (+pthreads).
Rewired all dynarecs and interpreter to return after every frame so that
libretro can process events. This required to make dynarec re-entrant.
Dynarecs were updated to check for new frame on every update (IRQ, cycle
exhaustion, I/O write, etc). The performance impact of doing so should
be minimal (and definitely outweight the libco gains). While at it,
fixed small issues to get a bit more perf: arm dynarec was not idling
correctly, mips was using stack when not needed, etc.
Tested on PSP (mips), OGA (armv7), Linux (x86 and interpreter). Not
tested on Android though.
twinaphex
David Guillen Fandos
bmaupin
aliaspider
Dave
notaz